Search results

The purpose of this standard is to give the candidate an understanding of the procedures that must be used in the safe hire of ladders and low level staging within the Provision and Use of Work Equipment Regulations (PUWER), Work at Height Regulations (WAH) and to industry lead body requirements for compliance at all levels.

---

This standard focuses on the use and application of the underpinning historical, technological and theoretical knowledge and the requisite practical skills to undertake the correct evaluation and selection of materials, tools, equipment and craft practices relevant to the history of clay tile and slate roofing.

---

This standard instructs demonstrators, with full knowledge on the operating commands of the equipment, ensuring that they are able to perform and demonstrate the emergency descent, carry out and demonstrate pre-use/daily and weekly inspections and ensure that these take place. In addition, demonstrators are responsible for performing familiarisation to users and trained operators.

---

The purpose of this standard is to instruct an operator how to operate the Construction Hoist (CH), with full knowledge of the controls of the equipment, enabling them to carry out pre-use/daily inspections and perform the emergency descent.

---

The purpose of training delivered against this standard is to provide candidates with an introduction to home construction, providing an overview of typical construction methods, terminology and technologies used within the UK.

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: geological classification and properties of stone used in heritage buildings, common stone types, their characteristics and geographical distributions, sourcing, selection, and compatibility of replacement stone, appropriate conservation treatments and repair methods, types of mortars and aggregate and how to match them.

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The details for this standard can be viewed on the HSE website.

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The details for this standard can be viewed on the HSE website.

---

The purpose of this standard is to provide the delegate with the knowledge to support the safe and correct application of liquid, multi-pack, resin and mastic asphalt Type A waterproofing systems.

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: To demonstrate the correct methods of: installing basic small internal stonemasonry components, safe working practices to move and handle resources, use or a range of tools to install basic small internal stonemasonry components

---