Search results

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems.

---

This training standard is in development and will be published shortly

---

The purpose of this standard is to provide the delegate with the knowledge to further support their learning with the following: carrying out pre and post installation checks; types of surface finishes; hazards with resources; protecting work and work area from damage; minimising thermal bridging; installing vapour control barriers; recognising specific requirements for structures of special interest, traditional construction and historical significance; recognising when specialist skills are required; how to communicate with your team and others; looking after tools and equipment; working at height and safe use of access equipment and harness systems.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to operate chemical cleaning equipment used for façade preservation.

---

The purpose of this standard is to provide the skills needed to be a safe and efficient vacuum lifter. It should cover an introduction to the machine and controls, correct lifting procedures and the operator's safety code.

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: examples and definitions of confined spaces, specialist personal protective equipment (PPE) including practice in the use of masks, harnesses, winches, gas monitors, escape breathing apparatus (EBA), full breathing apparatus (full BA) and BA control, paperwork and documentation, safe systems of work, monitors, bump test, peak readings, gas hazards and alarm levels, fall arrest equipment, winches, tripod and harness, duties and responsibilities of personnel (e.g. winchman, top man/bottom man duties, BA controller), theory and practical exercises and assessments, emergency procedures, mechanical resuscitator, the importance of reporting accidents, ill health and other incidents (RIDDOR)

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following: Scope:  examples and definitions of confined spaces, specialist personal protective equipment (PPE) including an overview of masks, harnesses, winches, gas monitors, paperwork and documentation, safe systems of work, monitors, bump test, peak readings gas hazards and alarm levels, fall arrest equipment, winches, tripod and harness, duties and responsibilities of personnel (e.g. winchman, topman, bottom-man), theory and practical exercises and assessments, emergency procedures, Reporting of Injuries, Diseases and Dangerous Occurrences Regulations (RIDDOR)

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: examples and definitions of confined spaces, specialist personal protective equipment (PPE) including practice in the use of masks, harnesses, winches, gas monitors, Escape Breathing Apparatus (EBA), paperwork and documentation safe systems of work, monitors, bump test, peak readings, gas hazards and alarm levels, fall arrest equipment, winches tripod and harness, duties and responsibilities of personnel (e.g. winchman, top man, bottom man duties), theory and practical exercises and assessments, emergency procedures, the importance of reporting accidents, ill health and other incidents (RIDDOR)

---

This standard is held by NSAR

---