Flat roofing (RBM) vapour control layers
This standard covers an introduction in understanding the necessity of a bituminous vapour control layer.
You are here:
Search results
Your search for under resulted in 200 matches. The standards are sorted in alphabetical order.
Use the Download as CSV button to save these search results to your computer. We update these standards frequently, so you should check the website and download a new version regularly.
Floor sawing - Refresher
The purpose of training against this standard is to provide the candidates with the knowledge and understanding of carrying out floor sawing operations safely,
Floor sawing Advanced - Refresher
The purpose of training against this standard is to provide the candidates with the knowledge and understanding of carrying out floor sawing operations safely.
Formwork construction and installation for foundations
The purpose of this standard is to provide the delegate with the knowledge to support the following: formwork vs other options; types of formwork/shuttering; construction and installation; risk assessment review; top tips for formwork construction/installation.
Gas membrane unloading, storage and preparation
The purpose of this standard is to provide the delegate with the knowledge and understanding to interpret relevant information required to unload, store and prepare gas membrane installation.
Gas membranes preparing to install
The purpose this standard is to provide the delegate with the knowledge to fully understand the prestart requirements of preparing to install ground gas membranes and venting systems.
Hand held diamond drilling - refresher
The purpose of training against this standard is to provide the candidates with
the knowledge and understanding of carrying out hand held diamond drilling
operations safely
Handling difficult situations
This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose of this standard is to enable the delegate to develop knowledge and understanding of handling difficult situations regarding performance, discipline, conflict, stress and diversity as required by a practising or potential site supervisor.
Health and safety in construction site management
The purpose of training delivered against this standard is to provide site managers with the ability to implement all health, safety, welfare, and environmental legislation. To understand new guidance and industry best practice and state their duties and responsibilities with regards to health, safety and welfare within the built environment.
Hire of cartridge and IC fixing tools
The purpose of this standard is to give candidates an understanding of policies and procedures relating to the safe hire of cartridge and IC fixing tools.