Search results

The purpose of this standard is to provide the delegate with the knowledge to support the following: Maintaining safe, healthy and environmental work practices, Understanding an assessment of significance, Interpreting information, Complying with legislation, standards, official guidance, Selecting resources, Identifying when specialist skills are required, Protecting work, Carrying out pre-installation checks, Preparing surfaces and substrate, Installing boards and making good, Carry out post installation checks, Handing over to the customer

---

The purpose of training delivered against this standard is to provide candidates with the knowledge to identify, resolve and report problems relating to dampness and/or timber infestation/decay in buildings.

---

The purpose of training delivered against this standard is to provide candidates with knowledge to install new basements and convert existing basements, including: design, planning, and installation of structural waterproofing projects below ground.

---

The purpose of this standard is to prepare candidates who have responsibility for manoeuvring vehicles on, off and within busy construction sites or premises to recognise the importance of accepting and dispersing vehicles in a safe and efficient manner, recognise significant risks and give clear and precise signals to vehicles.

---

The purpose of this standard is to provide the delegate with the knowledge to build on the learning from the 'Getting Started with Digital Construction' module. This course considers digital tools in a bit more depth.

---

The purpose of this standard is to provide the candidate with the knowledge to install tapered insulation systems.

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the delegate with the skills and knowledge to support the operation of Telescopic handler – suspended loads Non-Rough Terrain (experienced)

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the delegate with the skills and knowledge to support the operation of Telescopic handler – suspended loads Non-Rough Terrain (Novice)

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the learner with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (experienced)

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the delegate with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (novice) .

---