Search results

The purpose of this standard is to provide learners with a detailed understanding of the content preparation and relevance of the contract data under the NEC Engineering and Construction contracts.

---

The purpose of this standard is to provide learners with an opportunity to increase their understanding of administration of timescales and failure to comply rules within a NEC Engineering and Construction Subcontract.

---

The purpose of this standard is to provide learners with an opportunity to increase their understanding of works information and site information and scope of work, under NEC Engineering and Construction Contracts.

---

Training covers: quality assurance; national Highway Sector Schemes; health & Safety; risk assessments/method statements; industry; guidance documents; chapter 8 of the traffic signs manual; types of work; safety zones; equipment and vehicles; basic layouts; maintaining closures; setting out traffic management; arrival on site; advance signs; taper installation; entering closures; removal of closures; safe taper positions; non-motorised road users; roundabouts.

---

Training covers: quality assurance; national Highway Sector Schemes; health & safety requirements; risk assessments/method statements; multi-phase systems; pedestrian traffic signals; non-motorised road users;; preparation; planning; installation and Commissioning of the system; timings; site maintenance; removal.

---

The purpose of this standard is to provide overview knowledge and practical skills in cold applied paint, including using a spray paint machine. This system is typically used in warehouses and car parks.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to safely set up and use the pedestrian applicator, to enable installing thermoplastic road markings.

---

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose of this standard is to enable the delegate to develop an understanding of effective planning and monitoring of work as required by a practising or potential site supervisor.

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the learner with the skills and knowledge to support the following scope.

---