Search results

The purpose of training delivered against this standard is to provide candidates with knowledge and skills to apply thermography as a diagnostic aid to determine the performance of a building.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to install pump-applied self-smoothing screeds based on a binder of calcium sulphate, in a weather-tight building envelope.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following: interpreting information, deploying signage and barriers, preparing, identifying services, repairing and renewing floor-boards, repairing and renewing decayed joist end(s) and wall plate(s), removing existing timber floor(s), laying suspended timber floor(s), repairing timber stud partition(s), replacing decayed timber lintels and trimmers, installing sub floor air vent(s), safe disposal of waste.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: examining poor and good practice; Building Regulations and industry standards; tolerances in wall construction; understanding the guidance and tolerances; identifying where to source the guidance documents.

---

This standard covers the principles of using a total station for site surveying and setting out. These principles can be applied to all types of construction including earthworks, roads, houses, buildings, foundations, piles, structural steel, structures, and reinforced concrete.

---

The purpose of this standard is to allow experienced hard metalworkers to extend their skills to cover more complicated roof shapes and methods required for the maintenance of the nation’s historic, and listed, buildings. It covers spires and cupolas using hollow wood cored rolls and welted joints.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following: selecting appropriate PPE, equipment checks and reporting procedures, how to set up and where to site equipment, using application equipment, cleaning and disassembling application equipment, the use of transformers and safety lighting

---

This training standard is in development and will be published shortly

---

The purpose of this standard is to provide the delegate with the knowledge and/or skills to understand the Building Safety Act.

---

The purpose of training delivered against this standard is to provide candidates with fundamental knowledge of the different types of building construction, and how the construction type will affect how a building performs.

---