Search results

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems.

---

This training standard is in development and will be published shortly

---

This standard is about applying printed murals to a wall area. It includes working with different types of murals and understanding their advantages and disadvantages. The standard also includes the required preparation of the wall area before applying the mural, the availability and suitability of different types of adhesive, Measuring, setting out and applying the mural to the wall.

---

The purpose of this standard is to provide the delegate with the knowledge to further support their learning with the following: carrying out pre and post installation checks; types of surface finishes; hazards with resources; protecting work and work area from damage; minimising thermal bridging; installing vapour control barriers; recognising specific requirements for structures of special interest, traditional construction and historical significance; recognising when specialist skills are required; how to communicate with your team and others; looking after tools and equipment; working at height and safe use of access equipment and harness systems.

---

The objective of this qualification is to provide analysts and similar specialists to have the knowledge to enable them to carry out inspection and testing of asbestos works that have been carried out to ensure they meet the correct standards required by HSG248.

---

The purpose of training delivered against this standard is to provide candidates with an understanding of the risks of exposure to asbestos and how to avoid work which may disturb asbestos-containing materials.

---

The purpose of this Asbestos Awareness Refresher standard is for delegates who have previously passed the full Asbestos Awareness course or subsequent refresher course and can provide proof of attendance.

---

The aim of this training is to provide background and practical knowledge in the surveying of buildings for asbestos, and to provide general guidance on management procedures necessary to minimise exposure to any identified asbestos.

---

The training course is for anyone who is responsible for buildings and their renovation / development / maintenance / demolition / design / management, including builders, surveyors, architects and pest controllers.

---