Search results

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems.

---

The purpose of this standard is to provide the delegate with the knowledge to further support their learning with the following: carrying out pre and post installation checks; types of surface finishes; hazards with resources; protecting work and work area from damage; minimising thermal bridging; installing vapour control barriers; recognising specific requirements for structures of special interest, traditional construction and historical significance; recognising when specialist skills are required; how to communicate with your team and others; looking after tools and equipment; working at height and safe use of access equipment and harness systems.

---

This standard focuses on the key knowledge and in-depth understanding in relevant architectural areas.

---

The purpose of this standard is to explain how frontline supervisors and managers can influence behaviours; how various types of human errors can cause accidents or incidents and how these can be eliminated or reduced. It also emphasises to frontline supervisors and managers their roles in engaging in positive health and safety conversations and providing constructive feedback to team members.

---

This standard focuses on skills needed to carry out bench joinery in a workshop and on site in a heritage environment.

---

The purpose of training against this standard is to provide candidates with knowledge of brick slip systems and what they are used for.

---

The standard covers the knowledge and skills to use their gas torches/hot air guns safely.

---

This standard focuses on skills which can be used to optimise control point accuracy, collect and manipulating survey data, set out using design information and calculating quantities. The content is relevant to all types of construction including earthworks, roads, houses, buildings, foundations, piles, structural steel, structures and reinforced concrete.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: the principles and characteristics of cartridge operated tools, suitable applications and safe use of cartridge operated tools, and care and maintenance of cartridge operated tools.

---

The purpose of Cartridge Operated Tools – safe use - refresher standard is for delegates who have previously passed training to the full Cartridge Operated Tools – safe use standard or subsequent refresher training and can provide proof of attendance.

---