Search results

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, communicate, measure, assemble, position, secure and clean, use and maintain hand and power tools, airless spray equipment and associated equipment, set up and adjust spray equipment to achieve the finish stated in the given working instructions, relating to the following: preparation of coatings, loading the system, monitor and maintain supply, apply water-borne or solvent-borne coatings by airless spray.

---

The purpose of the Introduction to spray painting using HVLP equipment - refresher standard is for delegates who have previously passed training to the Introduction to spray painting using HVLP equipment standard or subsequent refresher training and can provide proof of attendance.

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems

---

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems.

---

The purpose of the applying printed murals - refresher standard is for delegates who have previously passed training to the applying printed murals standard or subsequent refresher training and can provide proof of attendance.

---

The purpose of this standard is to provide the delegate with the knowledge to further support their learning with the following: carrying out pre and post installation checks; types of surface finishes; hazards with resources; protecting work and work area from damage; minimising thermal bridging; installing vapour control barriers; recognising specific requirements for structures of special interest, traditional construction and historical significance; recognising when specialist skills are required; how to communicate with your team and others; looking after tools and equipment; working at height and safe use of access equipment and harness systems.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to apply venetian polished plaster and micro cement to an existing dry lined or wet-plastered wall and ceiling. This scope of this standard excludes dry lining or wet-plastering of a wall or ceiling.

---

The purpose of this standard is to outline the training that is needed to become a competent installer of Architectural and Decorative metalwork.

---

The purpose of this standard is to refresh the training that is needed to become a competent installer of Architectural and Decorative metalwork.

---

The purpose of this standard is to outline the training that is needed to become a competent installer of Architectural and Decorative timber.

---