Search results

The purpose of this standard is to provide the learner with the knowledge and skills to support the following scope: demonstration of work skills to prepare, load, protect, measure, assemble, position, secure and clean, use and maintain hand tools, power tools, air spray equipment and associated equipment, set up and adjust spray equipment (high-volume low-pressure [HVLP] systems) to achieve the finish stated in the given working instructions, relating to: preparation of coatings, loading the system, monitoring and maintaining supply, apply water-borne or solvent-borne coatings by high-volume low-pressure [HVLP] air spray systems.

---

This standard is about applying printed murals to a wall area. It includes working with different types of murals and understanding their advantages and disadvantages. The standard also includes the required preparation of the wall area before applying the mural, the availability and suitability of different types of adhesive, Measuring, setting out and applying the mural to the wall.

---

The purpose of this standard is to provide the delegate with the knowledge to further support their learning with the following: carrying out pre and post installation checks; types of surface finishes; hazards with resources; protecting work and work area from damage; minimising thermal bridging; installing vapour control barriers; recognising specific requirements for structures of special interest, traditional construction and historical significance; recognising when specialist skills are required; how to communicate with your team and others; looking after tools and equipment; working at height and safe use of access equipment and harness systems.

---

The purpose of this standard is to outline the training that is needed to become a competent installer of Architectural and Decorative metalwork.

---

The purpose of this standard is to refresh the training that is needed to become a competent installer of Architectural and Decorative metalwork.

---

This standard focuses on the key knowledge and in-depth understanding in relevant architectural areas.

---

The objective of this qualification is to provide analysts and similar specialists to have the knowledge to enable them to carry out inspection and testing of asbestos works that have been carried out to ensure they meet the correct standards required by HSG248.

---

The purpose of training delivered against this standard is to provide candidates with an understanding of the risks of exposure to asbestos and how to avoid work which may disturb asbestos-containing materials.

---

The objective of this qualification is to provide learners with the knowledge and understanding to be able to carry out analysis of samples in the workplace.

---

This standard covers the theoretical skills needed to undertake work on sites (brownfield and greenfield sites) which have been identified as having asbestos containing materials within the soils; or in which asbestos containing materials have been identified

---