Facebook Pixel
Skip to content

Search results

Your search for All resulted in 377 matches. The standards are sorted in alphabetical order.

Use the Download as CSV button to save these search results to your computer. We update these standards frequently, so you should check the website and download a new version regularly.

Telescopic handler: all sizes excluding 360 slew (novice)

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the delegate with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (novice) .

Telescopic handler: all sizes excluding 360 slew training

Grant is only available for this standard for achievements up to 30 September 2023.

Telescopic handler: all sizes including 360 slew practical test

Full details of this standard will be published shortly.

Telescopic handler: all sizes including 360 slew training

Full details of this standard will be published shortly

Temporary suspended access cradle operator

The purpose of this standard is to cover information relating to all aspects of operation of temporary suspended access equipment especially with regards to safety, technical processes and emergency procedures.

Thermal insulation for single ply roofing

The purpose of this standard is to provide the candidate with the knowledge to install thermal insulation.

Tiling in wet rooms

The purpose of this standard is to provide the candidate with the knowledge and skills to select and install tiling in wet rooms such as: bathrooms, kitchens, toilets, laundries, steam rooms, and swimming pool areas.

Tiling to calcium sulfate (anhydrite) screeds

The purpose of this standard is to provide the candidate with the knowledge and skills to install pump-applied self-smoothing screeds based on a binder of calcium sulphate, in a weather-tight building envelope.

Timber treatment building repairs

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following: interpreting information, deploying signage and barriers, preparing, identifying services, repairing and renewing floor-boards, repairing and renewing decayed joist end(s) and wall plate(s), removing existing timber floor(s), laying suspended timber floor(s), repairing timber stud partition(s), replacing decayed timber lintels and trimmers, installing sub floor air vent(s), safe disposal of waste.

Tolerances and standards for bricklaying occupations

The purpose of this standard is to provide the delegate with the knowledge to support the following: examining poor and good practice; Building Regulations and industry standards; tolerances in wall construction; understanding the guidance and tolerances; identifying where to source the guidance documents.