Search results

This standard focuses on the use and application of the underpinning historical, technological and theoretical knowledge and the requisite practical skills to undertake the correct evaluation and selection of materials, tools, equipment and craft practices relevant to the history of clay tile and slate roofing.

---

The standard is in development and will be published shortly.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following scope: introduction to spray painting, health & safety in spray painting, understanding paint materials, understanding airless spray, understanding conventional spray, understanding plural spray

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: Interpreting information. Understanding current legislation, standards and official guidance. Checking the suitability, compatibility and characteristics of the materials, components and finishes and determine if they are moisture open or moisture closed and their impact on the building. Carrying out pre-installation checks. Identifying common building defects. Recording and reporting issues or defects with materials. Implication of the type of construction and materials for the introduction of energy efficiency measures. Sequencing of energy efficiency measures. Understanding how continuity of insulation and building treatments can prevent problems. Causes of mould and fungal decay. Impact of ventilation and air flow. Specific requirements for buildings and structures with statutory protection, of traditional construction, hard to treat and buildings of historical significance.

---

This standard is about producing marbling effects. Preparing and using materials, components, tools and associated equipment. Providing protection to the work area.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: • understanding of the Code Of Practice Design Recommendations. • correct use of welding equipment. • how to fabricate substrate of Dormer with underlay and wood rolls. • understand the ventilation pathways and details. • correct use of tools to fabricate & install gutter front apron with dormer cheeks and upstand flashings. • how to fabricate & install dormer cheeks with front jamb, revel and head coverings. • understand types of dormer roof and associated drainage. • how to Install dormer cover using central wood roll, rear upstand to tiled/slated roof with fixed welted edge down stand. • correct way to recycle waste materials

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations, correct use of welding equipment. how to fabricate & install flashing components using welding and bossing techniques. how to fabricate & install a chimney penetration through a slated/tiled pitched roof. understanding the suitability of flashing fixing methods in masonry. correct way to recycle waste materials.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations, correct use of welding equipment, correct use of tools to install and fabricate roofing details, how to fabricate & install flat roofing with bossed & welded roll ends and abutments with rolls staggered. how to fabricate & install 3 -10 degree sloping roofing with bossed & welded roll ends and abutments with rolls in line. how to fabricate & install pitched roof above 10 degrees with wood rolled, hollow roll & welted joint including fixings. how to fabricate & install parapet gutter with step details. how to fabricate & install box gutter sump with circular spigot outlet, how to fabricate & install box gutter chute to hopper through wall. correct way to recycle waste materials

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations. correct use of welding equipment. correct use of tools to install weathering components. how to install welted parapet and cornice capping’s with wood roll and pipe penetration. how to correctly fabricate & install tiled/slated valley, ridge and hip weathering’s including fixing and clipping roll ends. correct way to recycle waste materials.

---

The purpose of this standard is to provide the delegate with the knowledge and/or skills to identify and describe a range of materials associated with heritage woodwork.

---